Wastewater Treatment Systems - page 45

• 45
High-Performance, Heavy-Duty
How It Works
The HighCycle is easy to install,
operate and maintain. Vehicle wash
water is collected in the Collection
Catch Basin (HT-CB) where trash, sand
and grit are removed. Wash water flows
by a gravity drain to the Triple Basin
Interceptor (HT-TB) for additional solids
and oil removal.
Water is drawn from the HT-TB's
effluent compartment using a sensor-
controlled, self-priming transfer pump
and forced through the hydrocyclone
where additional solid particles are
removed and transferred back to
the interceptor.
The workhorse of the system is the
high performance oil/water separator
(R-HTC) with Corella
®
and Petro-Screen
Coalescers to effectively remove free
oils down to 20 microns. A high-oil level
sensor in the R-HTC will indicate the
need for stored oil removal.
At this stage, a second sensor-controlled,
self-priming transfer pump draws water
from the R-HTC clear-well and forces
it through the bag-filter for final solids
removal. Pressure gauges on either
side of the bag filter unit permit manual
monitoring of solids collection.
The final oil removal process is
performed by the Advanced
Hydrocarbon Filtration System (AHFS).
These specially treated oleophilic
cartridge filters remove mechanically
emulsified and semi-miscible oils.
Cartridges can be visually inspected
for oil capacity. They are easily replaced
in a matter of minutes, requiring
no special tools, equipment or
back washing.
A clean water storage tank is provided
as a reservoir for the final ozone
treatment process. Ozone, which helps
purify the wastewater, is produced on
site in the Ozone Generator. Ozone
is added to oxidize any remaining
contaminants and keep the water free
from bacteria and odor. The final pump
recirculates the water in the tank and
completes the cycle by providing a
clean, pressurized water source for
the facility's vehicle wash system.
System
Oil/Sand R-HTC Oil/Water
Filter Skid
Model
Rate
Catch Basin
Interceptor
Separator
Footprint
HSC
Gal/Min
Model
Model
Model
Approximate
10
10
CCB - 55
550
300
8'-0" x 6'-0" x 2'-0"
25
25
CCB - 125
550
600
8'-0" x 6'-0" x 2'-0"
50
50
CCB - 150
1,000
900
9'-0" x 6'-0" x 3'-0"
*Filtration component skid dimensions subject to change as required by site and application requirements.
** Interceptor size may vary based on sludge and oil storage requirements and individual site conditions.
HT-TB Triple Basin
Oil/Sand Interceptor**
AHFS Cartridge
Filter Unit
Wash-Water
Holding Tank
Ozone
Generator
Transfer Pumps
Hydrocyclone
Control
Panel
HT-CB
Collection
Catch Basin
R-HTC Oil/Water Separator
with Optional Sludge Hopper
Pressurization and Ozone
Circulation Pump
Bag Filter
Water
Make-up
Valve
HighCycle Sizing Guide
1...,35,36,37,38,39,40,41,42,43,44 46,47,48,49,50,51,52,53,54,55,...58
Powered by FlippingBook